EVO 6.4 LWB Curved kit

New curved kit, a slightly more challenging construction than our other designs this kit is suitable for people who are handy Diyer’s . Side unit with lift up work top flap and storage 3 x Sliding tambour door Aluminium extrusion to all corners Over bed locker for low roof and elevating roof vans Front bed panel with door and rear bed panel The worktop cut for Smev 9722 – 2 burner hob and sink. (Smev 9222 will not fit) Concealed self close hinges with flush fitting doors Table with folding aluminium leg and stainless steel sliding rail system All connecting blocks, hinges, grey, black or silver edging, push catches and screws Designed for the Vitrifrigo C51I (trimming of van metal floor lip required) or Waeco cr 40 (compressor will need to be positioned in the next cupboard) Knock on edging for all exposed edges, the edges are pre slot cut for you to apply Designed to be easy to construct with easy mount hinges, slots for aligning the panels and pre drilled hole for the connector blocks Available in a range of own light weight ply finishes Worktop and Table can be a different finish Edging: Silver, Black or Dark Grey Works with Scopema RIB seat 1300mm (max length 1860mm) Works with both low roof and elevating roof conversions Front loading fridge, with storage flap above Narrow part of worktop lifts up to provide easy access, at only 270mm deep it allows space for a 1300mm wide bed **Does not include smaller swing out table LED light shelf under bed electrical box   NOTE: if using a 49/50L fridge, it sits further back in this unit (see images) which requirers the internal metal work of the van to be cut. Does not fit a twin sider van due to the thicker C pillar with our some customer modification. Only the work top will fit and the under units will need additional scribing to fit a twin slider. SaveSave SaveSave SaveSave SaveSave SaveSave SaveSave SaveSave SaveSave